Appleton Campbell’s 50+ Point Heating and Cooling System Check

Just like a car, your heating and cooling system needs service and regular system checks to run efficiently and avoid unnecessary breakdowns.  A full inspection from Appleton Campbell ensures routinely scheduled preventative maintenance of your heating and air conditioning systems. This helps protect your family from unexpected and sometimes costly expenses from equipment breakdowns. A System Check from Appleton Campbell is designed to keep your system running at maximum efficiency. This results in lower energy costs as well as improved comfort, safety, and convenience for your family.  Our primary goal at Appleton Campbell is to provide your family with uninterrupted comfort.

Top 10 Reasons to get the Ultimate System Check:

1. Save up to 30% on your utility bills.
2. Avoid unnecessary emergency breakdowns.
3. Prevent costly repairs.
4. Improve comfort and temperature stability.
5. Routine maintenance doubles the life span of the average residential air conditioning system.
6. Most health risks associated with home air quality can be dramatically reduced with proper system maintenance.
7. A complete system replacement is 70% more likely to be required in systems that have NOT had routine maintenance.
8. Safeguard your home and family.
9. Be environmentally friendly by saving fuel and energy.
10. Enjoy peace of mind!

50+ Point Checklist Includes: 

• Check indoor coil.
• Check primary drain for dirt, cracks, and rust. 
• Flush condensate drain. 
• Check auxiliary drain pan (if applicable).
• Check blower for dirt and balance of blower.
• Check blower motor bearings and amperage.
• Check for proper airflow. 
• Check filters. 
• Check thermostat.
• Check wiring and connections.

• Check condition of outdoor coil.
• Check outdoor fan for balance.
• Check fan motor bearings.
• Check relays for contact wear.
• Check capacitors for proper capacitance.
• Check reversing valve operation.
• Check defrost cycle (fall check only).
• Check compressor voltage and amperage.
• Check operating temperatures and pressures.
• Check that all covers, caps and seals are in place.

• Check heat exchanger condition.
• Check draft inducer motor and fan. 
• Check flue pipe condition. 
• Check drain on condensing furnace.
• Clean flame sensor. 
• Test furnace safety switches (pressure, temperature, draf,t and rollout).  
• Check gas valve operation.
• Measure gas pressure and adjust, if needed.
• Check condition of burners.
• Check operating temperatures. 

• Check relay/sequencer operation.
• Check heater voltage and amp draw.
• Check operating temperatures.

• Check any parts/operation unique to equipment.

Check out our Home Savings Agreements for regularly scheduled maintenance and save 15% on any Plumbing, Heating, Cooling, or Electrical repairs!

Call us toll free at 866-543-3996 to speak to one of our friendly staff members.